20  Foot  Tower  Construction

 

A  Quad  antenna  at  33  feet  supported  by  the  20  foot  Tower

 

 

The  modest  20  foot  Tower

 

This  tower  was  originally  a  windmill  tower  but  it  can  be  built  from  scratch...

It  basically  consists  of  four,  7  metre ( 23 foot )  lengths  of  galvanised  angle  iron,  60mm  wide  and  4 mm  thick,  a  metre  of 

which  is  concreted  into  the  ground...  The  width  of  the  base  at  ground  level  is  about  1.3  metres ( 4.5  feet )...

The  windmill  tower  was  disassembled,  refurbished  and  painted  at  my  home  QTH  in  Adelaide  and  then

  transported  150  kilometres  to  the  Radio  QTH  near  the  town  of  Morgan...

 

 

 

 

The  holes  were  dug  and  the  tower  assembled  using  new  galvanised  nuts  and  bolts... 

It  was  then  erected  by  two  of  us  using  a  long  pole  to  push  it  up  and  into  the  holes...

 

 

 

 

 

 

 

 

 

 

Four  holes,  one  metre ( 3 feet )  deep  had  been  dug  with  the  central  area  dug  to  a  depth  of  400mm  to  allow 

reinforcing  rod  to  connect  the  legs  diagonally...

 

 

About  2.5  cubic  metres  of  concrete  was  poured  to  support  the  tower...

 

 

A  concrete  base  was  poured  to  support  the  rotator  and  antenna...